This standard long rack (with mesh floor) is made without a sunroof cutout and will add much needed cargo space to your vehicle to tackle your adventures. The installation is done directly to the body frame without drilling, the outside frame is made of 1 inch tubing and the flooring with 1/2 inch cold roll steel tubing and 3/4 inch steel mesh.
This rack was designed around the 4 factory mounting positions on the roof of the vehicle without obstructing the operation of the sunroof, there is a cutoff on the floor of the rack to avoid interference with the roof antenna. No drilling required.
IF YOU BUY A RACK + LADDER PLEASE CHECK THIS NOTE:
Before you install your new BajaRack ladder check the gap on top of the hatch it needs to be 5/16” to 3/8” inch, if the upper top of the ladder does not enter the gap on the hatch do not install, and check the gap clearance with a dealer or shop.
EXTREMELY IMPORTANT NOTE:
Please verify the lip (edge) measurement before purchasing or installing your ladder, the standard dimension is between 0.100” (0.254mm) and 0.200” (0.508mm) if this dimension is larger than 0.200” (0.508mm) don’t install the ladder, Toyota in some models applies more sealant in this area that can cause the ladder to not fit.
Each rack includes all mounting brackets, stainless steel hardware, and aluminum wind deflector.
Material and Thickness: 1” (25.4mm), ¾” (19.05mm),1/2’”(12.7mm) Steel tubing and ¾” (19.05mm) Steel mesh. Top Wind Deflector: 0.062” (1.57mm), 5050-H32 Aluminum Finish: Epoxy primer (rust inhibitor) with black powder coating Rack weight: 95 Lb (43.1 Kg). Load Capacity: Dynamic (while driving) 300Lb (136 kg); Static 600Lb (272 kg) Measurements: 91”(2311.4 mm) Long x 46” (1168.4 mm) Wide x 5” (127 mm) tall Total Height (Top of roof to top of rack): 8.25" Mounting method: Roof mounts (2 front adjustable brackets and 4 support brackets)