5th Gen 4Runner Roof Rack - Utility with SPY Light System (LED bar not included) (flat)(2010-2023)
This low profile, flat Toyota 5th Gen 4Runner roof rack includes a SPY light system and is built with US-Made, cold-rolled steel tubing and best-in-class powder coating to ensure quality.
The rack includes our SPY Light System that is compatible with vehicles equipped with or without sunroof. With a turn of a switch reveals your hidden LED bar you can adjust the beam angle to give you maximum range. The top of this rack is completely flat to transport large objects such as lumber, canoes, rooftop tents, etc. This rack was designed around the 4 factory mounting positions on the roof of the vehicle without obstructing the operation of the sunroof, there is a cutoff on the floor of the rack to avoid interference with the roof antenna. No drilling is required. LED Bar not included.
Spylight System is a Special UTility Rack and can't be retrofitted to our regular racks.
Includes rack, all mounts, stainless steel hardware, aluminum wind deflector, Spy Light actuator system, and Spy Light cable & switch. Compatible with Bajadesigns 40” S8, Rigid Industries 40" E-Series, and, with a bar support (please call to order this item separately), Vision X 35" XMITTER Low Profile LED bars. LED Lightbar and LED cable/switch are not included.
IF YOU BUY A RACK + LADDER PLEASE CHECK THIS NOTE:
Before you install your new BajaRack ladder check the gap on top of the hatch it needs to be 5/16” to 3/8” inch, if the upper top of the ladder does not enter the gap on the hatch do not install, and check the gap clearance with a dealer or shop.
EXTREMELY IMPORTANT NOTE:
Please verify the lip (edge) measurement before purchasing or installing your ladder, the standard dimension is between 0.100” (0.254mm) and 0.200” (0.508mm) if this dimension is larger than 0.200” (0.508mm) don’t install the ladder, Toyota in some models applies more sealant in this area that can cause the ladder to not fit.
Each rack includes all mounting brackets, stainless steel hardware, and aluminum wind deflector.
Material and Thickness: 1” (25.4mm) and 1/2”(12.7mm) Steel tubing
Wind deflector: 0.062” (1.57mm) 5050-H32 Aluminum
Finish: Epoxy primer (rust inhibitor) with black powder coating
Rack weight: 97LB (43.99Kg)
Load Capacity: Dynamic (while driving) 300Lb (136 kg); Static 600Lb (272 kg)
Measurements: 47” (1193.8 mm) Wide x 92.5”(2349.5 mm) Long x 4.5” (114.3 mm) tall
Total Height (Top of roof to top of rack): 5"
Cargo area: 24.68ft² (2.29m²)
Mounting method: Roof mounts (2 front adjustable brackets and 4 support brackets)