Toyota 4runner 2012 Roof Rack | Utility Flat with Sunroof Cutout

This flat, low-profile Utility Toyota 5th Gen 4Runner roof rack has a sunroof cutout and is built with US-Made, cold-rolled steel tubing, and best-in-class powder coating to ensure quality. 

The top of this rack is completely flat to transport large objects such as lumber, canoes, or rooftop tents. If garage height is a concern, this rack is the best option. The installation is done directly to the body frame without drilling, the outside frame is made of 1-inch tubing, and the flooring with ½ inch cold roll steel tubing.

This rack was designed around the 4 factory mounting positions on the roof of the vehicle without obstructing the operation of the sunroof, there is a cutoff on the floor of the rack to avoid interference with the roof antenna. No drilling is required.

IF YOU BUY A RACK + LADDER PLEASE CHECK THIS NOTE:

Before you install your new BajaRack ladder check the gap on top of the hatch it needs to be 5/16” to 3/8” inch, if the upper top of the ladder does not enter the gap on the hatch do not install, and check the gap clearance with a dealer or shop.

EXTREMELY IMPORTANT NOTE:

Please verify the lip (edge) measurement before purchasing or installing your ladder, the standard dimension is between 0.100” (0.254mm) and 0.200” (0.508mm) if this dimension is larger than 0.200” (0.508mm)  don’t install the ladder, Toyota in some models applies more sealant in this area that can cause the ladder to not fit.